Topband
[Top] [All Lists]

Re: Topband: RFI - and lots of it

To: topband@contesting.com
Subject: Re: Topband: RFI - and lots of it
From: Jim Brown <jim@audiosystemsgroup.com>
Reply-to: jim@audiosystemsgroup.com
Date: Thu, 29 Oct 2015 10:39:45 -0700
List-post: <topband@contesting.com">mailto:topband@contesting.com>
Exactly right.

NQ6N asked about how to ground his new QTH. For about ten years, I taught classes at trade shows on the topic of power and grounding for audio and video contractors. Slides for those sessions are at

http://k9yc.com/InfoComm-PowerSystems2012.pdf
http://k9yc.com/InfoComm-Grounding2012.pdf

An extensive "White Paper" on the topic is at

http://k9yc.com/SurgeXPowerGround.pdf

Earlier in this thread I posted a link to a tutorial I have given at Pacificon and at several ham clubs on the topic, this time focused on ham installations. I'll post it again. It's exactly what Matt is looking for, and it' what any ham ought to be studying carefully.

http://k9yc.com/GroundingAndAudio.pdf

73, Jim K9YC

On Thu,10/29/2015 5:07 AM, Tom W8JI wrote:
Jim,

Just keep in mind when you do the work, the quality of the house ground to earth is far less important than having everything entering the house being bonded to act like one common point.

One of the biggest mistakes in amateur radio grounding over the decades has been having the shack antenna and control cable entrance ground non-existent, and the common shack desk equipment ground to an independent ground.

The shack ground must be bonded to the mains ground so everything entering the house is as close to one potential as you can get it.

Correcting things may not cure your RFI, but it always makes things much safer and more reliable.

_________________
Topband Reflector Archives - http://www.contesting.com/_topband

<Prev in Thread] Current Thread [Next in Thread>