I have installed and used messenger cabled RG-59, RG-6 and 1/2" hardline for
years. The current installation at N5BG/NI5T has more that 6,000' of 1/2"
hardline w/ messenger on poles (three separate runs of 2,000'+) from the
Beverage collection, signal splitting and selection point to the shack.
There has never been any indication of the messenger wire inducing any
external noise onto the signals.
In all cases with these three varieties of cable, the messenger is NOT
common with the shield. The messenger wire is totally isolated and
insulated from the coaxial shield.
Mis dos centavos.
73 de Milt, N5IA
=========================================================
-----Original Message-----
From: Mike Waters
Sent: Sunday, February 08, 2015 7:14 AM
To: Carl
Cc: topband
Subject: Re: Topband: Tensioning of RG58 coax for 2-way Beverage
I can imagine some installation scenarios where the messenger cable might
pick up noise that coax alone would not. But would that *always *occur? The
messenger cable is, after all, in the same location as the coax shield.
73, Mike
www.w0btu.com
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5646 / Virus Database: 4281/9076 - Release Date: 02/08/15
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|