Do a sloper (half WL) and feed in the center.
Half of one of the half go to the other side, like an inverted V
73, Jorge
CX6VM/CW5W
Enviado desde mi iPhone
> El 24/12/2014, a las 17:10, "James Wolf" <jbwolf@comcast.net> escribió:
>
> I used to use a similar method on 80 meters.
> Why not feed it (them) at the top?
>
> Jim - KR9U
>
> -----Original Message-----
> From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Jim Brown
> Sent: Wednesday, December 24, 2014 1:46 PM
> To: topband@contesting.com
> Subject: Re: Topband: 160m Sloping Vertical Antenna?
>
>> On Wed,12/24/2014 10:29 AM, Ed via Topband wrote:
>> Trying to figure out how to best utilize my 106' tower for 160m. The
> tower sits on a small hill so the downside of the tower is sloping. If I
> hang a wire off the top, I can bring the other end to the ground and feed it
> at the bottom. I can ran numerous radials from there.
>
> That's exactly what I'm doing -- my tower is 115 ft with roughly 7 ft of
> mast above it and a 3-el SteppIR. I have sloping wires on two opposite
> sides, supported from the tower just below the rotator with a 10 ft section
> of 4-in PVC conduit. Each wire has its own set of 4 radials elevated about
> 18 ft. The tower, which is grounded, has a dozen or so radials laying on the
> ground.
>
> With this configuration, the tower will act as a reflector, yielding about 6
> dB front to back. How much GAIN you get will depend on your radial system
> and the quality of your soil. I started with radials elevated only a few
> feet, and gain was poor. On the advice of N6BT, I raised them and gain
> improved.
>
> 73, Jim K9YC
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|