Hello Gary,
I have been using the K9AY loops for several years and am very happy with the
performance but always looking for more. Is there anything critical about the
placement of the radials, i.e. in the same directions as the loops or at 45 deg
in between the loops?
Thanks,
Russ, N3CO
________________________________
From: K9AY <k9ay@k9ay.com>
To: topband@contesting.com
Sent: Tuesday, October 21, 2014 10:57 AM
Subject: Re: Topband: The Stew
In the Pre-Stew, I did not have the regular RX antennas installed (neither K9AY
nor Beverages); only used a couple 200 foot unterminated wires quickly deployed
at 2 ft. height. Quiet band was very helpful! All corners of US/VE among my 65
QSOs, including VE1, FL, CA, OR, WA, KV4FZ and VP5. Heard OA4 and KH6 while
they were S&P, but I only operated 3 short sessions, didn't call CQ much and
didn't work them. Heard whispers of DX an hour before sunrise (VK-something,
and another unknown).
Saw several comments on the K9AY Loop -- I've done a lot of analysis and
experiments over the past couple years that are not yet published. Among the
results is better understanding of the role of ground. I now recommend a few
radials for all installations: minimum of (4), preferably (8) radials that are
twice as long as the loop's footprint. If you add them to an existing system,
remember that the resistor should be readjusted for deepest null.
73, Gary
K9AY
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|