Hi Pete,
You can use your MFJ 259 to measure loss through your bias-T setup.
100 microhenries should be adequate; however, a properly designed bias-T should
always have two inductors at the injection and and two at the far end of the
coax cable. The series inductor isolates the power injection port from the RF
path and and an inductor to ground protects the RF electronics (preamps and
transceivers) from damage if the series capacitor feeding that port should
short.
My bias Ts use simple homebrew inductors, just a few turns of wire on a ferrite
core. Use your MFJ-259 to optimize the inductors.
73
Frank
W3LPL
----- Original Message -----
From: Pete Smith N4ZR <n4zr@contesting.com>
To: Topband@contesting.com
Sent: Thu, 14 Nov 2013 07:58:47 -0500 (EST)
Subject: Topband: bias tee
I am using my coax to feed 12 VDC to my remote RX antenna locations,
using a traditional bias tee, but am having some trouble with
performance. I'm using 100 uH Radio Shack chokes in my bias tee, and am
wondering if perhaps that is insufficient inductance for 160 meter
operation. If so, what would be an appropriate value?
--
73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.
_________________
Topband Reflector
_________________
Topband Reflector
|