You've been watching over my shoulder, Rick.
Mis dos centavos de Milt, N5IA
-----Original Message-----
From: Richard (Rick) Karlquist
Sent: Tuesday, May 07, 2013 3:27 PM
To: donovanf@starpower.net
Cc: PVRC ; topband
Subject: Re: Topband: Problem with compression F connectors on Quad RG-6
On 5/7/2013 9:23 AM, donovanf@starpower.net wrote:
3. Remove the foil tape between the two braid shields. Do not use a knife
to assist
in foil tape removal. This step is time consuming and often ignored. The
connector
will be very difficult to install if the foil tape is not removed. If
somehow you manage
to force the connector onto the cable with the foil tape in place, the
connector will
be intermittent and unreliable.
This is the key issue with these things. I find that I simply cannot
tear the foil with my bare hands, on account of the fact that it
is not foil, but rather plastic (probably mylar) with an evaporated
or sputtered metal coating. I have resorted to using a very small pair
of diagonal cutters to cut the "foil". Any other suggestions?
Rick N6RK
All good topband ops know how to put up a beverage at night.
_________________
Topband Reflector
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3272 / Virus Database: 3162/6306 - Release Date: 05/07/13
All good topband ops know how to put up a beverage at night.
_________________
Topband Reflector
|