Thanks guys for your direct or via reflector pieces of advise.
Just a remark : the 25 ohms is correct in the input/serial configuration
suggested by Bryant&Bower in the article I have mentioned previously while
the 100 ohms is the right one in the most common output/parallel
configuration of a splitter.
On the basis of all that, I am in the process to make some cut and try tests
with different cores and turn numbers using my VNA 2180 .
I am planning to test the two configurations (common and Bryant&Bower ) and
will advise you of my final results.
More info about the need : I cannot use a commercial splitter because I am
intending to use two of them in a to be constructed switching box (as small
and light as possible) which will dispatch two 75 ohms beverage inputs (JA
and NA/EU directions) to two radios. One radio being for example the 80m
radio and the other the 160m radio. The outputs to the radios must be 50
ohms because those outputs are going to the radios via W3NQN RX band filters
and we want have the filters at they best in a multitransmitter environment.
In the same spirit, the switching system manages to put a 50 ohms resistor
at the unused output of the splitters. To finish, each operator will have a
remote switch next to his radio to choose its directions. The common mode
rejection at the inputs is just a precaution for expedition places where the
quality of station ground is far from optimal.
73, Gilles VE2TZT
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|