On 10/16/2011 11:31 AM, Missouri Guy wrote:
>> If not, what does everyone else use for a
>> receiver
>>
>> frontend protection?
> Scott,
>
> I use a "front end saver". Homebrew from CQ Magazine, Feb 1997.
> I think Far Circuits still sells a circuit board for that, but it's
> a simple device to build, so perfboard will work too.
>
> 73,
> Charlie, N0TT
> _______________________________________________
> Charlie,
The DXE RTR-1 is superb in performance, design and construction. I have in
the past built a relay driven unit derive with a Darlington 2N2222 from the H
send output on the radio. i have even in a pinch used the MFJ-1026 Noise and
Phasing unit which has a built in relay circuit for power through. This way I
put the RX antenna(s) bank on the "noise antenna" input and turn down the main
antenna pot. This way I also have use of the onboard pre-amp if i need it and
noise phasing against the TX antenna.
73
Herb Schoenbohm, KV4FZ
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|