>From DX Engineering's manual for the RBS-1P Reversible Beverage System
manual:
"The antenna ladder-line is connected between the feed point and reflection
units observing the polarity between the units. The + side of the ladder
line on the feed point unit should be connected to the + side of the
reflection unit. Since you may be twisting the ladder line along its length,
correct polarity should be verified using a meter. An incorrect connection
will result in poor front-to-back ratio or sensitivity."
It is my understanding that W8JI designed the RBS-1P. It would be
interesting to hear his comments on this paragraph.
73,
Ken - K4XL
On Thu, Aug 11, 2011 at 12:43 PM, Bob Eldridge <eldridge@direct.ca> wrote:
> 1. It could be a convenient accident.
> 2. If on purpose, the answer is probably "Just in case this is
> useful". But then you would expect DXE to draw attention to it .
> 3. Useful that this has been "discovered" and brought to our
> attention.
> Bob VE7BS
> >> So other than phasing two Beverages, has anyone found a reason why
> >> DX
> >> Engineering does this?
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
--
Ken - K4XL
BoatAnchor Manual Archive
BAMA - http://bama.edebris.com
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|