>Will these connector types cause allot of loss to the incoming signal or do I
>just solder on the >coax as though they were pl-259's
No measurable loss will occur if you just solder cheap radio shack RCA
connectors to the coax or use adapters to some more common RF
connectors. I doubt you'd get measurable loss if you taped the coax
into the connectors ;-)
Here's a photo I took of a chain of 18 or so adapters, including some
very cheaply made phono adapters, passing 100W at 1.8MHz with not even
a watt of noticeable loss:
http://n3ox.net/files/Adapters.jpg
So the total loss, including a mating pair of cheap phono connectors,
is less than 0.04dB.
Even if the connectors *were* lossy (which they never noticeably are)
little bit of loss doesn't matter so much in a receiving system. Your
20dB is unlikely to be exactly the amount you need to limit on the
external noise floor, so you'll probably have a little surplus gain
anyway.
There might be some really cheap phono connectors that will be
mechanically unreliable and become intermittent, so spending a couple
bucks for decent connectors is probably still worth it.
73,
Dan
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|
