Topband
[Top] [All Lists]

Re: Topband: using mfj analyzer

To: microsys@alltel.net, topband@contesting.com
Subject: Re: Topband: using mfj analyzer
From: w2pm@aol.com
Date: Sat, 13 Oct 2007 10:56:41 -0400
List-post: <mailto:topband@contesting.com>
>>----Original Message-----

>>From: G B <microsys@alltel.net>
>>To: TopBand <topband@contesting.com>
>>Sent: Fri, 12 Oct 2007 10:27 pm
>>Subject: Topband: using mfj analyzer

Hello,

Would I be able to tell anything by putting my mfj ant analyzer at the
output (lowZ) side of my flag antenna?

Although it seems to work ok, it is not as wonderful as I had read 
about.
I measured it on a couple signals to the NE, and seemed to be 20-23db 
down
from
the invL.

I have ordered the vacuum relays to start the 160M mod to the SB-220 
amp.  I
found
it very difficult to work dx that are S7 or less on the invL.  Ones 
that are
S8 or above
are not a problem.  I feel like I am the only one running 'qrp' ;-)

73's

Glen K4KV


Glen - what would you be looking to read on the low impedance side??  
All you need is an ohmmeter to see if your load resistor is in the 
circuit.  On the output side the analyzer will show you how flat your 
SWR is over the band(s) - that will tell you how good your transformer 
is - should be as flat SWR as possible and certainly be a low SWR.

Re the output level YES - the Flag is at least MINUS 30DB from a 
resonant Inv L ..  That's why you need preamp most of the time.  The 
signals can be quite low even with a preamp but the S/N level will make 
them quite readable. That's the point of the Flag - better S/N, not 
higher signal levels.

73 Pete W2PM

_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband


________________________________________________________________________
Email and AIM finally together. You've gotta check out free AOL Mail! - 
http://mail.aol.com
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband

<Prev in Thread] Current Thread [Next in Thread>