Topband
[Top] [All Lists]

Re: Topband: Coax Shield vs. Ground & elevated radials

To: w8ji@contesting.com, topband@contesting.com
Subject: Re: Topband: Coax Shield vs. Ground & elevated radials
From: W2pm@aol.com
Date: Sat, 30 Dec 2006 09:24:39 EST
List-post: <mailto:topband@contesting.com>
 
In a message dated 12/29/2006 10:11:06 PM Eastern Standard Time,  
w8ji@contesting.com writes:

With  elevated radials near earth there can be a dB or more 
FS reduction when  the feedline shield is not decoupled.

This says nothing about the  unwanted coupling of noise into 
the antenna, or RF into other devices  close to the feedline 
or operated from the power line.

73, Tom  



I have a pea-shooter station and this is 100% true. When I ran elevated  
radials on my Inv L with 800 watts - I had a very poor QSO hit rate without the 
 
choke baluns - and I purposely tested this by going out and bypassing  them.  
Couldn't make a Q without them - with them in  - no problem 90%  of time.  Now 
with 30 or so on-ground radials I still have them in line (2  - 50 bead 
covered coaxes) but they are likely not needed as my feedline is 150  ft buried 
coax 
into the shack.
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband

<Prev in Thread] Current Thread [Next in Thread>