AD3F wrote:
"My shunt wire consists of two parallel #14 wires separated from each
other by 18 inches and held off the tower face two feet. Perhaps this
arrangement is what helps my shunt-fed tower exhibit such a broad BW
on 160M."
==========
A Swedish ham on this reflector used a similar shunt feed. Out of
curiosity on how much the two wide-spaced wires would increase the BW
over a single shunt feed wire, I modeled his tower with both types of
shunt feed.
The two-wire shunt feed increased his BW from about 100 kHz to about 105
kHz. The biggest difference was that the two-wire shunt feed had to
connect to his tower several feet higher to hit the 50-ohm "sweet spot".
73, de Earl, K6SE
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|