Tony, KB8JVH wrote:
"Modeling this in EZNEC 3 with the radials 3" off the ground shows
pattern skewing of -2 to -3db in the direction of no radials.....
.... is the skewing from wires being to close to the ground in EZNEC?"
==========
You are correctly modeling on-ground or buried radials in EZNEC3 by
modeling them very close to ground. If you use EZNEC's real - high
accuracy ground model, your azimuth pattern results will be quite
accurate.
73, de Earl, K6SE
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|