Topband
[Top] [All Lists]

Topband: Toploading question

To: <topband@contesting.com>
Subject: Topband: Toploading question
From: herbs at vitelcom.net (Herb Schoenbohm)
Date: Thu May 29 12:18:24 2003
Dave,  The 3/16 EHS  will work just fine to form a capacity hat. There 
will be some cancellation of  effectiveness depending upon the guy wire 
angle of declivity. However, you can buy most of this back by connecting 
a perimeter wire to each 20' section at the insulators.  I have not 
modeled this but was introduced to this idea in the 60's by a well known 
BC antenna consultant, John Mullaney. (Mullaney and Associates) This 
method was used at KQRS in Minneapolis where I used to work.  I recall 
that by installing the perimeter wires the base impedance increased by 
12 ohms. I think the practice is well worth the effort as there is 
little cost involved for the benefits received.  However this means of 
top loading is not in widespread use with top banders although it is 
really a simple way to buy some efficiency with top loaded towers.

Good Luck,

Herb Schoenbohm, KV4FZ

Raymond Dave-CSUS04 wrote:

>
>I am planning on top loading each element with a top hat consisting of the 
>upper 20' of the guy wires attaching at the 70' level.
>My question is this. . . is the guy wire a sufficient
>conductor or is it too resistive for this application?  I will be using
>standard 3/16" EHS guy wire.  
> 
>73. . .Dave
>W0FLS 
>_______________________________________________
>  
>


<Prev in Thread] Current Thread [Next in Thread>