Would appreciate helpful suggestions on how to locate a break in a single
wire Beverage. Perhaps there's a piece of test equipment that will do this?
Visual inspection of the 14AWG stranded/insulated wire reveals no obvious
cuts in the wire, yet dc voltage applied to one end isn't getting down to
the far end. It was definitely intact a few months ago. The wire's been up
for 18 mos and been subject to a fair amount of stretching, falling
branches, etc. and already has a few splices in it.
Thanks for any help & happy new year to all,
Barry N1EU
--
FAQ on WWW: http://www.contesting.com/FAQ/topband
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|