One year ago I install a shunt-fed in my self-supported tower 65 feet high, in
order to work the band of 160m. Up of the tower is installed a KLM 20M-5.
The gamma-match is mounted with number 10 wire a distance of the tower of 22"
and it goes from the top of the tower (65 feet) until the box of the air
variable capacitor (1/14"- 250pf) that is 24" of the ground.
It is necessary to add that I have an earth of excellent conductivity and a
good ground system.
The SWR is 1:1 with the capacitor working to about 100 pf and the bandwidth is
reasonable. I have arcing only with my 3CX1500A to full power and when it
rains. If I reduce a little the power the arcing disappears even raining.
This installation supplemented with an EWE for 160/ 80m in reception, has
provided me good results and this me encouraged to prove of making a shunt feed
to the tower for the band of 80 meters and it is here where I need advice.
In the band of 80 meters the wire of number 10 is parallel to the wire of 160m
in a distance of the tower of 15" and it goes from the level of 28 feet until
the same box of the air capacitor for 160 meters, but using other air capacitor
1/ 14"- 250pf.
The line of feeding (RG-213) is common for the two bands (160/ 80). The design
is similar that of W6SAI in their book "Beam Antenna Handbook " page 65 "The
Tri Match Gamma".
In definitive the shunt feeds are in parallel. I know that this system could
create any problem of harmonics.
The result is that seemingly the antenna of 160 meters has experienced no
modification in their parameters (remain analyze the diagram of radiation).
I have measured with my MFJ-259 to the exit of the box of the gamma before and
after installing the shunt-feed of 80m and the SWR continue being 1:1 and of
course, with a resistance of 50 ohms.
Adjusting the air capacitor to minimum SWR it remain at about 100pf in 3,700
and the SWR to 1:4, and the resistance is only 10 ohms. The correct resonance
is in 5,300 with the air capacitor working with a few pf, almost in their
residual.
I have proven of adapting the impedance with a second air capacitor (omega
match), without any result
I have also moved the gamma wire closer and farther from the tower, only for
the part of the connection to the gamma box, without any apparent result.
With these data could somebody suggest me for where continuing?
Going up or lowering the taking of the gamma in the tower ?, exist interaction
with the wire for 160m and this change the measures of the gamma for 80
meters?, maybe there is others alternatives?
Thank you in advance for the advice.
73 from Barcelona.
Alberto Perello
EA3CR
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|