On Tue, 21 Oct 1997 19:49:41 -0400 (EDT) Frank Donovan
<donovanf@sgate.com> writes:
>Charles,
>Here are some direct answers to your questions:
>
>On Tue, 21 Oct 1997, Charles H. Harpole wrote:
>> 1. just how long should it be (not in wavelengths, not in meters,
>but in
>> gud ole American FEET) for 160 meters????
>
>Based on computer models, and on-the-air experience, good choices are
>580,
>880 and 1160 feet. If these are inconvenient for you, use what you
>can.
>Lengths less than 500 feet perform significantly poorer than longer
>lengths.
>
>> 2. what should be on the far end? a carbon resistor? or what? and
>of
>> what wattage value? and of what resistance value?
>
>Use a 470 ohm carbon composition resistor. If you have an antenna
>analyzer, you could optimize the resistor value for flat VSWR across
>the
>range 1.8-10 MHz. If you don't have an antenna analyzer, don't worry
>about it, just use 470 ohms! VSWR flatness indicates minimal
>reflections
>from the far end. Wattage value is not critical, I've used everything
>from 1/2 watt to 2 watts and none have ever failed at my QTH.
Yeah, but you roll it all up during T Storm weather season Frank. I used
to blow at least 4 2W carbons every summer; just from induced voltages.
Finally went to three 180 Ohm 10W non-inductive in series. No problems
all this year. The 180 Ohm value was just what I found at a "junk store"
in quantity AND cheap.
>You will need a 9:1 transformer to feed the Beverage, and suitable
>ground
>rods at each end.
>
>Lay the feedline on the ground or bury it. If you must raise the
>feedline
>above ground it will also behave like a Beverage and you will need to
>take
>special precautions to isolate the antenna currents on the feedline
>shield
>from the Beverage feedpoint ground.
If you have various critters in the woods they may destroy soft coax in a
few months. I lost some nice runs to bite marks that sucked up the water.
The worst time was in the winter with a deep snow cover. The little
monsters did their work under the snow and when it melted I wound up with
700' attenuators.
Finally went to CATV hardline.
73 Carl KM1H
>73!
>Frank
>W3LPL
>donovanf@sgate.com
>
>
>
>
>--
>FAQ on WWW: http://www.contesting.com/topband.html
>Submissions: topband@contesting.com
>Administrative requests: topband-REQUEST@contesting.com
>Problems: owner-topband@contesting.com
>
--
FAQ on WWW: http://www.contesting.com/topband.html
Submissions: topband@contesting.com
Administrative requests: topband-REQUEST@contesting.com
Problems: owner-topband@contesting.com
|