Good afternoon, Scott:
I don't have an Orion 2, so I don't know. Do you have the service manual or
schematic handy? I do have an Omni 546-C, and the frequency counter has a
trimmer capacitor, as you might see in a frequency counter.
When you transmit to our fellow hams, do they squawk that you are a few
hundred hertz off frequency?
73,
AA2PM, Paul Mondok
Before printing this document, please think about the environment.
-----Original Message-----
From: TenTec [mailto:tentec-bounces+aa2pm=earthlink.net@contesting.com] On
Behalf Of Scott Sheppard
Sent: Sunday, January 1, 2023 5:19 PM
To: tentec@contesting.com
Subject: [TenTec] Orion 2 100hz off
Thanks Paul...read my mind...everything I have done points to that. That's
why early on I asked if there was some sort of read out adjustment...you
know, as you would calibrate a freq counter?
I have consistently arrived in the same place with all the tests so far.
TX is the same freq as what I am receiving....100hz higher (on 20m for
example)
I feel the problem lies elsewhere but do not know enough about the radio.
As well, would the counter be out a simar amount as well? Ie, very little on
80m but aver 195hz are 25mhz?
S
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|