| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] hex set screw size for Century 22 |
| From: | Garry Nichols <garrnich@gmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 21 Oct 2022 15:47:12 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
Does anyone know what size the tiny set screws that hold the knobs on are? They measure about 1 mm for the hex opening but that is an estimate. My rig is #666 in case there was a change across the production run. Are they metric or English? TU, Garry WA1GWH near Syracuse, NY _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Jupiter screen, Paul Kraemer |
|---|---|
| Next by Date: | Re: [TenTec] hex set screw size for Century 22, Andrew Moore |
| Previous by Thread: | [TenTec] Jupiter screen, Paul Kraemer |
| Next by Thread: | Re: [TenTec] hex set screw size for Century 22, Andrew Moore |
| Indexes: | [Date] [Thread] [Top] [All Lists] |