Had the same problem years ago. It was the balanced modulator. It only
did it in LSB. There are 2 pot to adjust it. I had to replace them
because they were unstable. Also check for bad solder joints around them.
GL, Ernie K2EP
On 1/19/2022 8:59 AM, John wrote:
My Omni 6+ has developed a problem. Here's the scenario
All bands
LSB only
Any power level setting
Keying the rig (pushing PTT) in LSB results in RF out even though the
mic gain is all the way down. The level of RF is about 10% of the
setting of the POWER OUT control (ie: set wide open, I see about 9
watts out when the mic is keyed).
This does NOT happen when USB is selected. Radio functions fine
otherwise.
Any suggestions on where to look to solve this ?
Thanks! I need my beloved Omni back and running well!
:-)
John K5MO
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|