Desk Microphone, Crystal Filters, Crystal,
Omni and Century 21 parts, and more For Sale:
.
TenTec 708 A Desk Microphone:
The 708 A deluxe base microphone is an Omni-
directional dynamic microphones designed for
use as a communications station microphone
for Amateur Radio and other transmitting
applications. It has a round 8 pin connector
and can be used without modification for
many Yaesu Transceivers in addition to
TenTec transceivers.
The unit consists of a metal die-cast base with
3 position PTT switch, flexible metal goose neck,
dynamic microphone element and ball-type
element housing. It has tailored frequency
response from 30 Hz to 12 kHz designed for
excellent transmit audio in SSB, AM, and FM
modes.
This one one looks like new. No defects of
any sort. Electrically, it works as it should.
With paper work for only $90.
.
Crystal Filters for TenTec Rigs For Sale:
I have a couple crystal filters for TenTec
rigs for sale. All work fine and look fine.
The following filters are used in TenTec rigs
in the 9 MHz IF. This includes the Omni
series A, B, and C; Omni V, Omni VI,
Argosy, Paragon, and Orion I.
While these will fit the original Orion,
they do not fit the Orion II.
The following are actual TenTec crystal filters:
TenTec 218 filter
1800 Hz wide, Narrow SSB or wide CW, $79
.
Crystal for 12 m for Omni series A or B
The early Omni series (A and B) did not include
the WARC bands, but they do have an "Aux"
position that can be used for the 12 meter
(24.8 MHz) WARC band, by simply plugging in
a crystal.
This is the crystal you need to do this.
It works fine. Only $18.
.
TenTec Omni 546 Parts For Sale:
I have a TenTec Omni D, Series B, Model 546 that I
am parting out.
Many, probably most, of the parts are compatible
with most all of the Omni series A, B, and C rigs.
PTO, digital readout and final module are
gone, but many, many parts are still available.
Available:
Metal parts:
Front panel
Rear panel
bezel
left and right sides
main chassis
Preamp assembly w/ metal work
Side plastic pieces that go between top
and bottom cover
3 switch module on left side
S Meter
S meter light and socket
Plastic PCB Holders
Offset pot
Drive pot
Selectivity rotary switch
Mode switch
Mic jack
Headphone Jack
Internal PC boards:
SWR / TR
T/R Relay
RF Trimmer
VFO Mixer / Oscillator
Low Level Driver
8 Pole Crystal Filter
Audio Amp
Low Pass Filter
SSB Generator
Attenuator
Maybe a few things not listed.
Please let me know what you need.
.
TenTec Century 21, Model 570 Parts For Sale:
I have parts from a Century 21, model 570, available.
Most of these parts should also fit the Model 574
digital version.
Hopefully these parts will let several rigs live again.
PTO, power supply parts, and final module are gone.
Available Parts:
Metal parts:
Inside front subpanel
Rear Panel
Both left and right sides
Main chassis
Large PS Filter Cap
Large Tuning Knob
Bandswitch Knob
Headphone Jack
3 pilot bulbs and sockets
12.500 Crystal
Circuit Board Assemblies:
Control board 80355
Audio Power Amp 80357
Front end board 80359
Low Pass Filter 80360
Please let me know what you need.
.
TenTec Original Boxes
These are original boxes only,
and do not include the equipment.
Inserts are included.
TenTec AC-5 QRP Antenna Tuner $8
TenTec KR-2 Keyer Paddles $5
TenTec 255 PS $20
TenTec 561 Corsair $30
TenTec 604 Keyer Paddles $5
These are original boxes only.
.
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.
.
Prices do not include shipping from Florida.
Thanks.
73,
Ken, W8EK
Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone (352) 732-8400
.
.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|