TenTec
[Top] [All Lists]

Re: [TenTec] Two topics: Tentec Eagle I2C Clock speed. Multi control err

To: "ah7i@gatech.edu" <ah7i@gatech.edu>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Two topics: Tentec Eagle I2C Clock speed. Multi control erratic.
From: Carlos PECO BERROCAL <carlos.peco@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 4 Feb 2021 10:34:24 +1100
List-post: <mailto:tentec@contesting.com>
I can make some captures on the I2C bus but not until the 20th or so (busy
weekends at the moment).

73,
Carlos


On Thursday, February 4, 2021, Bob D. <ajamas.rn@gmail.com> wrote:

> 1. Does anyone know the I2C clock speed in the Eagle 599.
>
> 2. I have two and a half Eagles. One of the two complete Eagles is
> misbehaving with regard to the multi-control.
> I don't want to replace the control if the problem is elsewhere.
> The symptom: Select something like CW speed or Power. Turn the
> multi-control. The indicated value jumps around. If I turn CCW it generally
> decreases but with jumps to higher and lower values. If I turn CW, it
> generally increases but with jumps to lower and higher values. I'm thinking
> it could be a problem with the control, signal levels, noise on the lines,
> ???
>
> What say?
>
> 73, -bob ah7i
>
>
> --
> -do not look into LASER with remaining eye!
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>