Hello
I had a Orion that had funny power It might work then it would drop power down
to 10-20watts . Dirty or bad alc pot. I cleaned the alc pot and worked fine
for two months then total drop off of power . Replaced pot back to working.
Adjusting power on the Orion isn’t the easiest thing to get right. Don’t
remember the the order of adjusting but mine didn’t like running 100 watts at
that setting it would go to 130-140 watts on some bands . But set it at 90
watts and it’s rock solid on all bands.
Why???
73s Byron AC9PA
Sent from my iPad
On Oct 24, 2020, at 5:49 AM, Enzo via TenTec <tentec@contesting.com> wrote:
My Orion does not handle the audio input correctly on several bands. By setting
the full power, on 160 and 80m it is OK, but on the others the ALC led does not
light and the output power is about on 20% (30% on 40m). The issue is present
both on MIC and AUX. Increasing the Speech Processor or the mic gain does not
help. On CW mode all bands are fine with full power output.Last year, the radio
did not work at all, but by following Bill (N4LG) and Gary (W0DVN) suggestions,
I changed all the caps of the A9 board and the radio was reborn. But I did not
check the audio input, as I use it mostly on CW and low bands. Now, I would
make some QSO on the CQ WW DX SSB contest and I have got the "surprise".Any
help will be really appreciated.Best 73 de Enzo, IK3SWB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|