S:
Please see photos at QRZ.COM forum page where I've also posted this
question.
https://forums.qrz.com/index.php?threads/white-rtv-adhesive-potting-how-to-remove.720133/
How to get that white crap off without spending $100+ on chemicals?
B:
I picked up an inoperative TenTec Eagle.
Photos are the low pass filter (LPF) board. That goop on the coils is NOT
from the TenTec factory!
In addition to the 'improvement' a few SMT parts have been removed.
A:
I'd like to restore the LPF board. Maybe repackage it along with the PA for
use with QRP transmitters if I can't repair the obviously damaged CPU board.
Toward that end, I'd like to get the goop off.
R:
Recommendation?
73, -Bob ah7i
--
-do not look into LASER with remaining eye!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|