You better use it or you’ll lose it! Hihi
Probably the hardest thing on a radio is not using it. I got a Orion and put
the Omni VI on the shelf . Well it happen A9 board caps gone bad in the Orion .
No big deal ordered caps got down Omni. Power up and no vfo .Ok case off
unplug and plug a few connectors and where back going just in time for our 160
gathering. About ten mins in radio starts acting up . A tap on top back going ,
5 more minutes all stop!
Spent the rest off night cleaning those pins. Backup and working fine caps
came in and again Omni goes on shelf. 8 months or so Orion down again bad pin
connections put Orion on bench to clean all pins upfront. Get down Omni (no
work) same as last time . Cleaned pins and back going again . AH
As far as worth in there day they where a fine radio (leading edge dsp) but
there time has gone. You can pickup a IC 7300 for under $1000 used I bought
for $600 . And no I would not give $600 for a Omni. Just seen a Ten Tec VII
sell for $600 about two weeks ago . I sold a Orion for $660 . The radio market
is saturated with old radios . Even the high end radios have been coming down.
And then the virus thing hit!
73s Byron AC9PA
Sent from my iPad
On Jul 31, 2020, at 11:37 AM, N4IJ <dougn4ij@gmail.com> wrote:
It would seem like I am advertising my OMNI6+ on this list but I have not
seen any listed on QTH or ebay lately for pricing. Right now am using my
OMNI6+ as backup to my FTDX5000MPL, so it sits on the shelf all the time
and does not get used. Fully loaded with filters, roofing filter, no
scratches, etc. For what I have seen a long time ago, I would think it is
worth more to me than letting it go - especially since I am 90% CW operator.
73 Doug N4IJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|