Re: [TenTec] looking for the remote tuning pod that works with the jupiter

[Carl Moreschi <n4py3@earthlink.net>]

My N4PY software will let you use a Flex control, or a behringer DJ 
controller or a Tentec pod as a knob.  The Behringer DJ controller is 
the best as it has a great tuning rate, 4 knobs, and many buttons.  And 
all can be customized by the user.  And the Behringer is only $100 from 
many websites.


Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com

On 8/26/2019 6:12 PM, Michael Tortorella via TenTec wrote:
> Could one do something like this for the Orion?
> 73, Mike W2IY
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Radio AI2Q
> Sent: Monday, August 26, 2019 8:02 AM
> To: tentec@contesting.com
> Subject: Re: [TenTec] looking for the remote tuning pod that works with the
> jupiter
>
> Dale, you can make one using an optical encoder. Mine is mounted in a
> small box that sits on the operating table. It communicates with my
> Omni-V via a cable and the RS-232 connector on the back of the transceiver.
>
> Vy 73, AI2Q, Alex
>
>
>
> On 8/25/2019 12:38 PM, dale via TenTec wrote:
> > HI
> >    Looking for the above ten tec tuning pod that the jupiter and other ten
> tec radios used. It was like the flex control used on flex radios.
> > thanks for looking
> > 73
> > dale
> > wt4t
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> ---
> This email has been checked for viruses by AVG.
> https://www.avg.com
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec