Ken suggested checking receive function in LSB (not USB) because LSB
receive is the same as CW receive, using the same BFO frequency, same BFO
crystal.
On Mon, Jun 17, 2019 at 8:54 AM dukeshifi <dukeshifi@comcast.net> wrote:
> Rig has no audio output in CW mode, appears to put out signal but no
> signal is heard - Ken suggested that you check USB, but you post suggests
> you already have done that. However, it is unclear what the result was. You
> said your friend could HEAR you but could not copy you. What do you mean?
> Were signals too weak or was he on USB and you were trying to be heard
> transmitting LSB? That’s not going to work. What happens if you are on
> transmitting on USB and he is listening on USB? If he still can’t “copy”
> you then you have other issues. Otherwise the LSB/CW BFO is a good thing to
> check.
> is heard. Does this even with key plug removed. Also, you say it appears
> that the radio appears to put out signal but but no signal is heard. Could
> you clarify this?
>
> While this is happening, if he switches to USB, rig seems to work, ie he
> could hear me on sked this morning in the USB position but couldn't
> actually copy.
>
> Numerous basic tests have been done. Thinking it a relay )as once it did
> work ok after this occurred, but no longer) I asked him to drop it from a
> couple inches to the table! No luck.- What you are experiencing does not
> sound like a relay problems.
>
> Writing this I realize I haven't asked him if it works ok in USB mode. but
> apparently it might. - ????
>
>
> Gary
>
>
> > On Jun 17, 2019, at 7:30 AM, Michael Rutkaus <mrutkaus@gmail.com> wrote:
> >
> > Rig has no audio output in CW mode, appears to put out signal but no
> signal
> > is heard. Does this even with key plug removed.
> >
> > While this is happening, if he switches to USB, rig seems to work, ie he
> > could hear me on sked this morning in the USB position but couldn't
> > actually copy.
> >
> > Numerous basic tests have been done. Thinking it a relay )as once it did
> > work ok after this occurred, but no longer) I asked him to drop it from a
> > couple inches to the table! No luck.
> >
> > Writing this I realize I haven't asked him if it works ok in USB mode.
> but
> > apparently it might.
> >
> > Any ideas?
> >
> > thanks
> >
> > Mike
> > K4QET
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|