The Century 21 uses the same with. I have one.
$15 shipped.
Gary
> On Mar 8, 2019, at 1:17 PM, Mike Bryce <prosolar@sssnet.com> wrote:
>
> Jim,
>
> that’s quite common. Someone at one time wired the power switch up to turn
> on/off the high current dc. That’s not how that switch operates. It controls
> the AC on the ten tec power supply.
>
> I’d bet the farm, that the contacts have been welded due to high current flow.
>
> You could contact the factory, but I bet that part is long gone out of stock.
> Try Allied or Newark for the part. It’s rather common pot with a switch on
> the end
>
>
> Mike, WB8VGE
> www.theheathkitshop.com <http://www.theheathkitshop.com/>
>
>
>
>> On Mar 8, 2019, at 1:56 PM, Jim C <1291jim@gmail.com> wrote:
>>
>> Hello All,
>>
>>
>>
>>
>>
>> The push/pull power switch has no effect on the rig. Just stays on as long
>> as power is supplied.
>>
>>
>>
>> Looking for some advice before I open her up.
>>
>>
>>
>> Thank you, es 73,
>>
>>
>>
>> Jim Crites
>>
>> W6JIM
>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com <mailto:TenTec@contesting.com>
> http://lists.contesting.com/mailman/listinfo/tentec
> <http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|