| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Molex Connectors? |
| From: | "P.C. Anderson" <xtraham58@hotmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 27 Dec 2018 19:04:09 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
Thanks Ben, found that out some time ago. The connector I need is the Molex 15 pin that is for the remote switching of the Hercules Amp. Andy...W3LI ________________________________ If this helps, these are the old 'Molex' connectors used for the Band Data in the Orion 565. Molex is now Tyco ( TE ) https://www.digikey.com/products/en?keywords=16405230 Ben - WB2RHM _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Molex Connectors?, Ben Antanaitis - WB2RHM |
|---|---|
| Next by Date: | Re: [TenTec] Omni V repair, Howie WA3MCK |
| Previous by Thread: | [TenTec] Molex Connectors?, Ben Antanaitis - WB2RHM |
| Next by Thread: | [TenTec] Omni VI+: low TX and RX on 12 meters, Phil Erickson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |