Does the fault occur on all bands? Does the frequency shown on the display
change when you tune the VFO knob?
The display in the Omni VI is not a counter. It simply reads the data going to
the two PLL’s and displays a number that represents what the radio’s frequency
SHOULD be, not what it actually is.
This suggests that there is an issue with data from the CPU board, because that
is the source of the digital information that appears on the display. The
display or its wiring could be at fault.
You state that the radio still can hear WWV on 10 MHz. This suggests that the
two PLL’s are working and are stable enough to produce the local oscillator to
the first mixer.
The CPU data also selects all of the LC filters that select the band at the
front end of the receiver.
However, this same data also selects the proper crystal for a given band on the
LO board so there is room for confusion here.
Since your CPU is indeed running, as evidenced by the fact that you can tune in
WWV, I would start looking for bad connectors between the CPU board and the
display, between the CPU and the two filter boards (not the crystal filters,
the LPF and BPF). These cables (with the white wires) were prone to fail and
they are an easy fix.
I have dozens of known-good one so no need to worry if you need one or more.
Gary
W0DVN
> On Aug 31, 2018, at 8:38 AM, L D Ritta <vk5abc@adam.com.au> wrote:
>
> Hello All
>
>
>
> I am new here and have just acquired an Omni 6 563, I was lead to believe it
> is an 6plus.
>
> It has a number of faults, first when you select 160m it displays 28mhz.
>
> Second the receiver is pretty deaf and it struggles to pickup wwv on 10mhz
> and very little else.
>
> Any suggestions, this is my first ten tec.
>
>
>
> 73's Lee
>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|