TenTec
[Top] [All Lists]

Re: [TenTec] Jupiter Display brightness

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Jupiter Display brightness
From: k4mt1950@charter.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 20 Jul 2018 06:41:16 -0600
List-post: <mailto:tentec@contesting.com>
Does the ribbon cable from the display to circuit board unplug at the
main board? I have looked but afraid to pull on it.
Unsoldering those pins on the display board might be a challenge
without getting too much heat on the ribbon cable.
Gary K4MT

        -----------------------------------------From: "Fernando" 
To: "Discussion of Ten-Tec Equipment"
Cc: 
Sent: Thursday July 19 2018 2:38:54PM
Subject: Re: [TenTec] Jupiter Display brightness

 Not to monopolize the thread, here is what

 I found in my Jupiter.

 The voltage regulator supplies 5V to

 parallel resistors, then 4.5v to J12.

 When I put 5V directly to J12, the backlight

 brittens up a bit but the graphics is still

 dim. So went ahead and ordered a new display.

 However, the new display looks like it

 won’t come with a connecting flat cable (FFC).

 Question to arGy, did you have to unsolder

 the 20 or so pins from the old display cable to 

 then to the new one? Or did your display

 come with a cable attached?

 BTW,, the R133 Contrast control is a coarse

 adjustment, and sensitive too.

 tnx..

 Fernando N2FQ/6
 n2fq@sbcglobal.net

 > On Jul 19, 2018, at 12:20 PM, Fernando  wrote:
 > 
 > Do you happen to recall the specifics?
 > 
 > Here is the one I’m eluding to on eBay:
 > 
 > Yeah.. I know kind of small, cut and paste.
 > 
 > 162294417788
 > 
 > 
 > 
 > Do you still have the old one? 
 > 
 > Like to tinker with it.
 > 
 > Fernando N2FQ/6
 > n2fq@sbcglobal.net
 > 
 > 
 > 
 > 
 >> On Jul 19, 2018, at 9:58 AM, MadScientist  wrote:
 >> 
 >> I did find a very nice exact replacement for the Jupiter display
on eBay.
 >> 
 >> Price was good, quality of the part was excellent.
 >> 
 >> arGy
 >> 
 >>> On Jul 19, 2018, at 11:39 AM, Fernando  wrote:
 >>> 
 >>> Just Contrast and Reverse ON/OFF.
 >>> 
 >>> Would have been nice to have had a brightness
 >>> entry though..
 >>> 
 >>> 
 >>> Fernando N2FQ/6
 >>> n2fq@sbcglobal.net
 >>> 
 >>> 
 >>> 
 >>> 
 >>>> On Jul 19, 2018, at 7:42 AM, Mike Bryce  wrote:
 >>>> 
 >>>> i’m not sure, but isn’t there a menu adjustment for
brightness and contrast?
 >>>> 
 >>>> 
 >>>> Mike, WB8VGE
 >>>> SunLight Energy Systems
 >>>> The Heathkit Shop
 >>>> http://www.theheathkitshop.com/
 /> >>>> J e e p
 >>>> o|||||||o 
 >>>> 
 >>>>> On Jul 19, 2018, at 9:58 AM, Bob McGraw K4TAX  wrote:
 >>>>> 
 >>>>> There is an internal contrast adjustment. Don't know if this
will help in your case. Replacement of the display is the option. And
where to get one.....don't have a clue.
 >>>>> 
 >>>>> 73
 >>>>> 
 >>>>> Bob, K4TAX
 >>>>> 
 >>>>> 
 >>>>> On 7/19/2018 8:48 AM, Gary Hendricks wrote:
 >>>>>> It seems my jupiter display is not as bright as it should be.
It was
 >>>>>> this way when I got it and dont have another radio to compare
it with
 >>>>>> but pictures I see online seem to have a much brighter screen.
Its the
 >>>>>> green screen.
 >>>>>> Its a great running radio and screen is still easy to see once
 >>>>>> contrast was adjusted. Is there a way to replace the backlight
on
 >>>>>> these displays? I know a display replacement is out of the
question.
 >>>>>> ThanksGary K4MT
 >>>>>> _______________________________________________
 >>>>>> TenTec mailing list
 >>>>>> TenTec@contesting.com
 >>>>>> http://lists.contesting.com/mailman/listinfo/tentec
 /> >>>>>> 
 >>>>> 
 >>>>> 
 >>>>> _______________________________________________
 >>>>> TenTec mailing list
 >>>>> TenTec@contesting.com
 >>>>> http://lists.contesting.com/mailman/listinfo/tentec
 /> >>>> 
 >>>> _______________________________________________
 >>>> TenTec mailing list
 >>>> TenTec@contesting.com
 >>>> http://lists.contesting.com/mailman/listinfo/tentec
 /> >>> 
 >>> _______________________________________________
 >>> TenTec mailing list
 >>> TenTec@contesting.com
 >>> http://lists.contesting.com/mailman/listinfo/tentec
 /> >> 
 >> _______________________________________________
 >> TenTec mailing list
 >> TenTec@contesting.com
 >> http://lists.contesting.com/mailman/listinfo/tentec
 /> > 
 > _______________________________________________
 > TenTec mailing list
 > TenTec@contesting.com
 > http://lists.contesting.com/mailman/listinfo/tentec
 /> 
 _______________________________________________
 TenTec mailing list
 TenTec@contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec
 />
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>