TenTec
[Top] [All Lists]

Re: [TenTec] Omni6 intermittent fault

To: tentec@contesting.com
Subject: Re: [TenTec] Omni6 intermittent fault
From: Bob McGraw K4TAX <rmcgraw@blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 24 Jun 2018 12:08:36 -0500
List-post: <mailto:tentec@contesting.com>
Sounds like time to clean connectors.  This generally applies to all radios which are 10+ years old.   Never spray anything into the radio!!!

Using a cotton swab such as a Q-Tip, apply contact cleaner to the cotton swab, unplug one cable, and wipe the male pin(s).  The plug in the cable and unplug it a couple of times to provide wiping action of the female contacts.  Usually this corrects 90% or more of all issues and the radio is good for another 10+ years.

73

Bob, K4TAX


On 6/24/2018 12:00 PM, Malcolm McLeman wrote:
Hi all...  Fault symptom as follows:-
At switch on Omni VI "motor-boating" before locking in then operates normally. Later it 
emitted  a "drift-like" sound as if going out of lock and again returned to normal.
Some days later after similar to above it drifted off completely then emitted a 
permanent low frequency buzzing noise in the LS which remained even when the 
Tune button was pressed.
All this time the O6 TX appeared to key and output normally but there was no 
sidetone only this buzzing from the LS..
Now all has returned to normal and I cannot pursue but would appreciate 
anyone's thoughts or who maybe has experienced same fault condx.
73

Malcolm/F5VBU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>