| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Scout Meter |
| From: | Stuart Rohre <Rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 07 Jun 2018 13:19:24 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Looking at the resistors that form the shunts for this meter-- should
help you back into the meter impedance. Look also at the D
E repair pages to see if factory manual was ever published to that list. GL, Stuart Rohre K5KVH _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] FILTER, Steven Jobes via TenTec |
|---|---|
| Next by Date: | Re: [TenTec] Scout Meter, Stuart Rohre |
| Previous by Thread: | Re: [TenTec] Scout Meter, Mike Bryce |
| Next by Thread: | [TenTec] FILTER, Steven Jobes via TenTec |
| Indexes: | [Date] [Thread] [Top] [All Lists] |