TenTec
[Top] [All Lists]

[TenTec] Fwd: Re: Fwd: Omni 6 pwr problem

To: tentec@contesting.com
Subject: [TenTec] Fwd: Re: Fwd: Omni 6 pwr problem
From: Steve Bookout <steve@nr4m.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 23 Apr 2018 19:11:54 -0400
List-post: <mailto:tentec@contesting.com>

Checking was not too easy here as I have mono band stations, with band specific high power band pass filters for my contesting efforts.  Trying 15 out was not an issue.  I just connected to the 15 meter port on my patch panel and all was good.  But, I have no way to try any WARC bands out on real antennas, even just listening.  I wound up just using a long piece of coax with the connected shield NOT connected at the watt meter.  On all bands I could hear substantial 'band noise', except for 15 meters and 12 meters, where it was graveyard dead.

So, no transmit or receive on 12 meters or 15 meters.

Steve

On 4/23/2018 10:31 AM, MadScientist1948 wrote:

You are correct about the thread regarding the various switching relays. They do fail causing lack of output. The fix is simply one of locating the defective one as there are several or each band.

Of course the other problem is locating good replacements…

I have a few dozen if you find that you need them. They are mostly of the newer type as seen in the Orions.

I assume your receiver performance is fine on these two bands?

The reason I ask is your description the problem, stating that both 12 and 15 are malfunctioning. This is suspicious.

The Omni VI shares a set of tuned circuits on the local oscillator/mixer board for 12 meters and 15 meters. Thus, a failure in that bandpass filter (located between and including D43 and D36 on the diagram for that board) will cause you to lose both bands on TX and RX on 12 and 15.

The most frequent reason for this failure is a marginal solder connection in that region of the board, not an uncommon thing for Ten Tec. The fix is to simply resolder all the connections on the filter for those two bands.

Gary

W0DVN

On Apr 23, 2018, at 7:48 AM, Steve Bookout <steve@nr4m.com> wrote:

Hello all,

I have very low/no power output on 12m and 15m. Fine on other bands.

'Somewhere' at 'sometime' I remember 'something' about relays on the output filter board being a possible cause.

'Someone' please refresh my memory on this. Or, maybe I 'somehow' imagined this; maybe in a thread I really wasn't following.

73 de Steve, NR4M

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Fwd: Re: Fwd: Omni 6 pwr problem, Steve Bookout <=