TenTec
[Top] [All Lists]

Re: [TenTec] Wanted: 7 pin PCB connector for Century/21 and other models

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Wanted: 7 pin PCB connector for Century/21 and other models
From: David Goncalves <davegoncalves@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 25 Jan 2018 09:39:23 -0500
List-post: <mailto:tentec@contesting.com>
replied directly - thanks!

On Wed, Jan 24, 2018 at 10:22 PM, MadScientist <dukeshifi@comcast.net>
wrote:

> On the back?
>
> I have a junker chassis and would go look at it if you tell me where it is
> located on the chassis.
>
> Gary
>
> > On Jan 24, 2018, at 1:33 PM, David Goncalves <davegoncalves@gmail.com>
> wrote:
> >
> > Back again for another part request - one of those 7 pin connectors used
> on
> > the Century 21 - I think those sort of chassis mount connector was used
> on
> > the Onmi C and other models of that vintage.
> >
> > Again, thanks.
> >
> > --
> > David Goncalves
> > W1EUJ
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>



-- 
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>