TenTec
[Top] [All Lists]

[TenTec] Omni D wiring

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] Omni D wiring
From: Shawn Upton via TenTec <tentec@contesting.com>
Reply-to: Shawn Upton <kb1ckt@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 31 Dec 2017 00:42:50 +0000 (UTC)
List-post: <mailto:tentec@contesting.com>
I'm rehabbing an older Omni D (Series B) and it looks like the wiring on the 
VOX board is wrong.  VOX is 80451.  It looks like I have the following:-red 
(12V)-white with orange stripe (speaker)-white with yellow stripe (? T/R?)-coax 
marked as #3 (mic?)
I think I'm missing a GND (can't find where this board gets GND from) and there 
is one solder terminal that is unused.
Anyhow: I had to lift the speaker connection to this board as it is clamping to 
60mV of audio, so it's clearly miswired.  This is a used radio, and I know 100% 
for sure that the PTO was removed, although the wiring on this VOX board looked 
unmolested--but one never knows.
I'd open up my Omni C but at the moment it's buried behind this D!  Might 
someone have a pic or know what I should look for?
shawn kb1ckt
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>