Hi Guys,
I have been dealing with a sick Centurion. Still having problems. I am going
to rebuild the QSK board and try again.
However, when I was testing the Centurion with my Orion 1, I had keying loop 1
connected and it was working….for a short time. Something happened when I was
testing and suddenly the amp would no longer key. I think the problem lies in
the QSK board. I’m sure something failed there again.
But, when the amp stopped keying, so did the radio. If I have the keying loop
turned on, the radio will not key at all. If I turn the key loop off, the
radio keys fine. if I turn on keying loop #2, the radio keys fine. So the
radio keys fine except when I have key loop 1 turned on in the menu.
So my question is, have I damaged keying loop #1? If so, what do I need to do
to fix it?
thanks for all of the expert advice!
73
Mike WB0SND
Michael Marx
sndtubes@vacuumtubes.com
636-939-9190
SND Tube Sales
105 N. Division St.
Bonne Terre, MO 63628
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|