Did you change your CPU battery?
Try that, then a hard reset.
See what transpires.
Gary
> On Nov 6, 2017, at 4:07 PM, Rod Greene via TenTec <tentec@contesting.com>
> wrote:
>
> During SSCW I noticed (after a few hours of operating) the number 9 creeping
> in from the right side of the display. It never completely became visible,
> but was definitely there and in large font. Later on in the SS a third
> megahertz number appeared on top of the regular megahertz numbers for each
> VFO. I could correct this easily by turning the OII off and back on. I was
> using N1MM+ in SO2V mode.
> Any thots on this or other similar experience? I have replaced the A9 board
> caps last year. And the display is working fine today.
> Thanks and 73, Rod/w7zrc
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|