Please ignore post.
I finally found it on page 12.5 of the FULL User Manual.
It can be set to off (which is disastrous), and then 10 to 30mS in
increments of 5 mS.
For Ameritron Amplifiers without the QSK-5, it should be set to 25mS.
Sorry I Spammed the group.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of
rick@dj0ip.de
Sent: Wednesday, September 20, 2017 5:52 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: [TenTec] OT: Question Connecting IC-7300 to AL-80A amplifier
Hi guys and gals,
A friend of mine (also OM6 user) just purchased an IC-7300 and wants to run
it with his AL-80A (slow open-frame relay).
He asked me if the 7300 can be adjusted for proper CW amp keying timing.
I know that he will need:
..> About 25mS TXD (delay of RF after keying the Amp Key line)
..> About 200mS hang delay
I found in the manual how to adjust the hang delay but I can't find any
description of the default RF delay or TXD adjustment.
Anyone here been down that road yet?
Thanks.
73
Rick, DJ0IP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|