If you have not already tried it, I would suggest you reflow all the solder
connections on that filter. It may recover.
DE N6KB
On Tue, Sep 12, 2017 at 4:56 PM, Stan Gammons <s_gammons@charter.net> wrote:
> I finally got around to doing a sweep of the filters on the PBT board in
> my Omni VI using the Midnight SNA. I think I see why the signal level
> shown on the S-meter increases when I switch from 2.4 Khz to 1.8 Khz. The
> 2.4 Khz filter has like 9 to 10 db more loss than the 1.8 Khz or 500 Hz
> filters. The extra 1.8 Khz and 500 Hz filters I have all measured roughly
> the same. I don't have another 2.4 Khz filter to compare to. Guess I need
> to find another one.
>
>
> 73
>
> Stan
> KM4HQE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|