Is this the Ten-Tec Wiki page you are referring to?
http://tentecwiki.org/doku.php?id=565pwrconn
Wolf was asking about an alternative feed point and I believe the answer is
no. The above link on the Wiki describes WC1M removing the Molex power
connector and running a cable directly from the PCB terminals where the
power connector had been soldered.
There's also this page that describes replacing the Molex power connector
with a PowerPole connector:
http://tentecwiki.org/doku.php?id=orion_molex_to_power_pole_mod
Barry N1EU
On Tue, Sep 12, 2017 at 7:57 AM, Greg S via TenTec <tentec@contesting.com>
wrote:
> See the Ten Tec Wiki page on it.
> --------------------------------------------
> On Tue, 9/12/17, Wolf Wita via TenTec <tentec@contesting.com> wrote:
>
> Subject: [TenTec] Powerplug on Orion
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Cc: "Wolf Wita" <g4ssx@yahoo.co.uk>
> Date: Tuesday, September 12, 2017, 12:54 AM
>
> HiI have completly muked up my Powerplug on
> my Orion 565 is there a alternative feed point where i can
> connect the Power to the Orion?Many Thanks73 de Wolf
> G4ssxg4ssx@yahoo.co.uk
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|