Picked up a desk mic, but while listening on a separate receiver I noticed a
fair amount of carrier. At first I thought 60Hz pickup, but I have it with out
any mic wire connected (just a connector with ptt tied to gnd). So I went to
adjust the carrier balance, but am confused. The manual has a pic showing the
tx board relative to all boards; it looks like what I have. Two trims and a
large shielded inductor. And no ic. But the page for the 80713 shows a 1496(?
off memory right now) ic and only one trimpot. Which is not what I have.
It looks like a running change, from a discrete design to an ic based one?
Regardless, how do I adjust?
shawn uptonkb1ckt
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|