rod,
I never even tried to do anything with computers.
don't know if it does that or not.
I'll leave that to the experts to answer.
Have fun,
Hal AA2ID
-----Original Message-----
From: Rod Greene via TenTec <tentec@contesting.com>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Cc: Rod Greene <w7zrc@yahoo.com>
Sent: Mon, Sep 4, 2017 3:10 pm
Subject: Re: [TenTec] Paragon 585 com port control?
Thanks again for the thoughts (Hal).. I'm wondering what software will control
the Paragon via the com port? I checked HRD and N1MM+ and neither has Paragon
listed as transceivers in their lists for radio setup and connection. Perhaps
it would work with the Omni VI selection? I downloaded a manual copy but it
doesn't contain any information about the command set for control. Thanks again
and 73, Rod/w7zrc From: Rod Greene via TenTec <tentec@contesting.com> To:
Rod Greene <w7zrc@yahoo.com>; Discussion of Ten-Tec Equipment
<tentec@contesting.com> Cc: Rod Greene <w7zrc@yahoo.com> Sent: Monday,
September 4, 2017 12:02 PM Subject: Re: [TenTec] Paragon 585 Well I finally
got the power supplies back in operation, so took a shot at the Paragon this
morning and the preliminary results are good. Full operation of all the
controls except I haven't tried the keypad settings on the right yet. Also full
power out on all bands and it sounds good on a second receiver (cw only so far).
Next I will hook it up to an antenna and see how it plays on the air. So far
it was just on a dummy load/power meter. Thanks again for the suggestions.73,
Rod/w7zrc From: Rod Greene via TenTec <tentec@contesting.com> To:
Discussion of Ten-Tec Equipment <tentec@contesting.com> Cc: Rod Greene
<w7zrc@yahoo.com> Sent: Sunday, August 27, 2017 3:12 PM Subject: [TenTec]
Paragon 585 All, I recently picked up a Paragon at a swap meet. It's really
dirty and probably hasn't been turned on in awhile. Any precautions or
suggestions before (and as) I put power to it and start checking it out?
Condition: One small cut out in the top panel and it has all the filter slots
filled. Looks complete and good otherwise.Thanks and 73,
Rod/w7zrc_______________________________________________TenTec mailing
listTenTec@contesting.comhttp://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________TenTec mailing
listTenTec@contesting.comhttp://lists.contesting.c
om/mailman/listinfo/tentec
_______________________________________________TenTec mailing
listTenTec@contesting.comhttp://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|