Read the instruction manual on the Anan.
I'm sure it has adjustable timing for the AMP-KEY line and the time it
generates RF.
Set such that you have a 10mS delay after keying the AMP-KEY, until the RF
begins to transmit. That is long enough for the 418's T/R relay.
The 418 has a feature built in that monitors its input. As long as there is
still RF on the input, it will not unkey its T/R relay, regardless of the
state of the AMP-KEY line.
If you don't understand any of this, you might want to take the time to read
the three pages explaining it, here:
http://www.dj0ip.de/ricki-leaks/amp-interfacing/
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Ed - K9EW
Sent: Friday, August 18, 2017 5:53 AM
To: TenTec Contesting
Subject: [TenTec] CW OPERATION WITH ANAN-10 AND TEN TEC 418
Has anyone operated CW with the Anan-10 and the Ten Tec 418 PA?
I'm not sure of the best way to do it. Key them simultaneously? Key the
Anan and let it key the 418? The other way around?
Would appreciate hearing from someone who's already done this.
Thanks - ed, k9ew
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|