To: | tentec@contesting.com |
---|---|
Subject: | [TenTec] End plates... |
From: | Stan Gammons <s_gammons@charter.net> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Wed, 9 Aug 2017 22:26:18 -0500 |
List-post: | <mailto:tentec@contesting.com> |
well I think that's what they are called. It's the plastic plates that
go on the end of the front panel. Does anyone here have a couple for a
model 960 power supply? I was thinking I saw a message someone posted
awhile back that they 3D printed these? I asked already, Ten-Tec
doesn't have them. Seems like they no longer have any of the parts I
ask for.
73 Stan KM4HQE _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] TenTec Digest, Vol 176, Issue 5 OMNI 6+ relays, Stan Gammons |
---|---|
Next by Date: | Re: [TenTec] paint, Ralph |
Previous by Thread: | Re: [TenTec] TenTec Digest, Vol 176, Issue 5 OMNI 6+ relays, Doug Snowden |
Next by Thread: | Re: [TenTec] End plates..., Stuart Rohre |
Indexes: | [Date] [Thread] [Top] [All Lists] |