If it’s off on all bands by the same amount, you might consider adjusting the
reference oscillator.
Gary
> On Jul 30, 2017, at 3:57 PM, Joe Papworth via TenTec <tentec@contesting.com>
> wrote:
>
> Barry is Da Man!
> <span style="font-size: 16px;">
> </span><div>I agree with leaving well enough alone
> on the 20 and 40 hz problem.
>
> My Omni 6 Plus was always dead on until I had to do some work on the Osc.
> board a year or so ago.
>
> It's now 20 hz off on all bands and modes but it's operationally perfect
> otherwise and I'm not gonna tempt OM Murphy.
>
>
> Sent from AOL Mobile Mail
>
>
> -----Original Message-----
> From: Stan Gammons <s_gammons@charter.net>
> To: tentec <tentec@contesting.com>
> Sent: Sun, Jul 30, 2017 03:41 PM
> Subject: Re: [TenTec] Omni VI questions
>
>
> On 07/30/2017 02:04 PM, Barry N1EU wrote:
>> Stan, if the 288 filter is plugged into your 9MHz i.f. board, remove it and
>> install it properly on the PBT board. That is a 6.3MHz i.f. filter.
>>
>> 73, Barry N1EU
>>
>>
>
> Hi Barry,
>
> Yep, it looks like someone put that filter in the wrong slot. I put it
> on the PBT board and the 1.8 Khz bandwidth setting works now. Thanks!
>
> I sent a message to the list with a pic of the 2 filters attached. But,
> it was too large and got put on hold.
>
> Thanks again for your help.
>
>
> 73
>
> Stan
> KM4HQE
>
> _______________________________________________
> TenTec mailing list
> <a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
> <a href="http://lists.contesting.com/mailman/listinfo/tentec";
> target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
> </div>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|