| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] no output eagle |
| From: | Katz Ajamas <ajamas.rn@gmail.com> |
| Reply-to: | ah7i@gatech.edu, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 17 Jul 2017 12:46:41 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
No output from Eagle A friend cross country is looking at one and there is no output. Does anyone know what the signal level is supposed to be going into the driver board? Thanks, -Bob ah7i/w4 -- -do not look into LASER with remaining eye! _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Orion, Bernie Skoch via TenTec |
|---|---|
| Next by Date: | Re: [TenTec] Omni VI Rubbery crud on PCB, Bwana Bob |
| Previous by Thread: | [TenTec] Orion, jfriend31 |
| Next by Thread: | [TenTec] no output eagle, jon greenwood via TenTec |
| Indexes: | [Date] [Thread] [Top] [All Lists] |