Hi Bob,
Thanks for the info. Sounds like the phone jack is the way to go. I have
had bad results trying to solder to DIN and mini-DIN connectors in the past
so would rather avoid that route. I plan to use DX Lab for logging and
control and N1MM+ for the IOTA contest at end of July. I have a Winkeyer
USB3 from K1EL so I think with the advice from the list here I can get this
all integrated into a working system (you may recall my op-ed from QST last
year about systems engineering..).
I bought a Herc II from a guy on the list here last December but the USPS
hit it with a forklift on the way here and it was completely trashed.
Fortunately, it was insured, although it took nearly 6 months to get the
claim paid. So am I still looking for one.
Mahalo & 73
Mike W2IY
_____
From: Katz Ajamas [mailto:ajamas.rn@gmail.com]
Sent: Thursday, June 15, 2017 1:02 PM
To: Discussion of Ten-Tec Equipment; w2iy@verizon.net
Subject: re: [TenTec] eagle 599 on CW
Aloha Mike!
Either will work. If you use the 1/8" jack make sure to wire your plug with
ring and sleeve shorted. The Eagle checks for this to learn if you have a
straight key or a paddIe connected.
I use the Eagle's internal keyer with a paddle. I also have a straight key
and N1MM logger in parallel. To make it work, I tell the radio I am using
the straight key or computer by cycling through the modes with the dash side
of the paddle closed.
I use a cheapo USB to serial converter with N1MM logger for keying computer
keying. If I recall correctly it's via the RTS line. The adapter was 99
cents from China. Being easily distracted and not particularly studious,
I've not yet learned to use the N1MM logger :-).
Why didn't I use the ACC connector for keying? The DIN plug connector for
that accessory socket is pretty tight soldering. It was enough
--
-do not look into LASER with remaining eye!
Message: 1
Date: Wed, 14 Jun 2017 23:57:43 -0400
From: "Michael Tortorella" < <mailto:w2iy@verizon.net> w2iy@verizon.net>
To: "'Discussion of Ten-Tec Equipment'" < <mailto:tentec@contesting.com>
tentec@contesting.com>
Subject: [TenTec] eagle 599 on CW
Message-ID: <4EA4F41D073949ABBF8C82057878EC9F@OfficeTowerDell>
Content-Type: text/plain; charset="us-ascii"
GE to the list,
I am about to put my new Eagle 599 on the air for the first time in the next
week or so and I am curious about how to use an external keyer. On page 18
of the manual it indicates that you plug an external keyer into the rear
apron with a mono 1/8" phone plug. Then on page 23, it appears you need to
use pins 2 and 3 of the ACC1 connector for external keyer input. I want to
run a K1EL winkeyer usb3 with computer control. Which of these options is
correct?
Thanks and 73
Mike W2IY
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|