Dave.....I think I once took the insulation off a blue or yellow butt
connector, and used the inside tube....as I was impatient. Regards, Greg,
KC8HXO
>
> On Jun 12, 2017 at 11:36, <W1Dwz (mailto:w1dwz@fullchannel.net)> wrote:
>
>
>
> There must be an old TENTEC guru aboard here on the Reflector, that has
> knowledge of where I can locate a tube-like pin removal tool to
> extract it from the body of the connector. It collapses the tangs to
> let the faulty connector back out of the nylon body. thanks for any
> replies. 73 Dave W1DWZ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|